Looking for good body/chassis/fabricator person...

[Gsolo]

So the Corolla I have has a seat rail bolt that pulled out of the floor. I was thinking I or a friend could weld it up...but thnkin some it may be better to have a "professional" who does this kind of stuff a lot do it. Especially if it may get scrutinized for NHRA in the future.

I wasn't sure who here feels comfortable doing a repair like this.

[Northwest outlaw]

I would say just plate the top and bottom with some 1/8 plate and you should be good to go.

[SRT Brian]

I agree take the seat out get some 1/8" cut it you could weld that to the floor then drill your hole and run a bolt tho it.

[Danimal]

Damn beer cans!!!! Use a fender washer on each side and bolt that thing back in... Why would NHRA ever care what was done to your seets in a beer can....

[Gsolo]

I've thought of plating it but didn't want to raise the seat any

[2bad]

why not just get it as flush as you can, weld the breaks, and weld a plate underneath? It'd be like a welded on washer and still provide support.. just a suggestion

[Gsolo]

i guess...just worried about blowing through I guess too. Floorpan can't be any thicker than a popcan

[HPI Performance]

do you have a welder? or access to one with gas?

[Gsolo]

do you have a welder? or access to one with gas?

Yeah, my buddy thats done bunch of exhaust work has wirefeed w/gas. Can't remember what mix of gas...but works great for exhaust.