JEFFRO
09-28-2006, 03:07 PM
Hi everybody its me Jeffro some of you may know me as good ol FNSR but since racing season is winding down to an end I will not be using that as a screen name until racing season picks up again in the spring!
But anyway I am starting my project of rebuilding my 1998 Mustang GT and thought I would share the ideas with you all .
So to star out with I'll be placing my Romero heads on the car and upping the compression to 10:1. Followed by freshening up all the Timing components and replacing the POS plastic intake manifold! I will be putting new cams in but not sure what cams I should go with. I'm goona put??a set of headers on not sure what brand I'm thing flow tech but have other ideas like maybe BBK but haven't pinned one down yet. I'm goona beef up the fuel injectors from the 19 lbs an hour to something that will keep up with all the new toys! Putting the 70mm throttle body on along with a cold air intake upgrading the spark plugs to anything better than motor craft! Going with the 10mm Taylor wires and Mallory coil packs! Putting a Mac H-pipe under the car to eliminate the O2 censors and a set of magnaflow mufflers. And last but not least a sniper tuning system to keep it all in check! I'll also be doing some suspension work as well to plant the power to the ground I'm thinking EIBACH springs but still not sure you know how it goes.
If any of you guys have a suggestions of what I should do I will gladly take any advise I can get!
I will post pics as they become avalible!
But anyway I am starting my project of rebuilding my 1998 Mustang GT and thought I would share the ideas with you all .
So to star out with I'll be placing my Romero heads on the car and upping the compression to 10:1. Followed by freshening up all the Timing components and replacing the POS plastic intake manifold! I will be putting new cams in but not sure what cams I should go with. I'm goona put??a set of headers on not sure what brand I'm thing flow tech but have other ideas like maybe BBK but haven't pinned one down yet. I'm goona beef up the fuel injectors from the 19 lbs an hour to something that will keep up with all the new toys! Putting the 70mm throttle body on along with a cold air intake upgrading the spark plugs to anything better than motor craft! Going with the 10mm Taylor wires and Mallory coil packs! Putting a Mac H-pipe under the car to eliminate the O2 censors and a set of magnaflow mufflers. And last but not least a sniper tuning system to keep it all in check! I'll also be doing some suspension work as well to plant the power to the ground I'm thinking EIBACH springs but still not sure you know how it goes.
If any of you guys have a suggestions of what I should do I will gladly take any advise I can get!
I will post pics as they become avalible!